DataRAM and Remote Telemetry Setup

Open the remote satellite telemetry briefcase (figure 6) and remove the required cables from the pouch.
Remove the satellite antenna in the top of the briefcase by slowly threading it through the retaining clips.
Screw the antenna into its magnetic base and attach the base's cable to the briefcase. The base of the antenna should be at least 3 feet off the ground for best results.
Attach the serial cable to the RS-232 port on the back of the DataRAM and to the serial connection on the briefcase.
Attach the power cord to the three-prong connector on the side of the briefcase and plug the cord into a 110-volt power outlet.
Ensure that all battery connections are snugly attached to the battery terminals.

Figure 6-DataRAM4 connected to the telemetry unit.

Visitor

since Dec 23, 2002