Skip to Main Content
Rake Angle for Planing Hard Maple Determined Best by Depth of Chipped GrainAuthor(s): Harold A. Stewart
Source: Research Note NC-116. St. Paul, MN: U.S. Dept. of Agriculture, Forest Service, North Central Forest Experiment Station
Publication Series: Research Note (RN)
Station: North Central Research Station
PDF: View PDF (782.02 KB)
DescriptionIndicates that rake angle for hard maple and perhaps other hardwoods should be determined by depth rather than frequency of machining defects.
- Check the Northern Research Station web site to request a printed copy of this publication.
- Our on-line publications are scanned and captured using Adobe Acrobat.
- During the capture process some typographical errors may occur.
- Please contact Sharon Hobrla, firstname.lastname@example.org if you notice any errors which make this publication unusable.
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationStewart, Harold A. 1971. Rake Angle for Planing Hard Maple Determined Best by Depth of Chipped Grain. Research Note NC-116. St. Paul, MN: U.S. Dept. of Agriculture, Forest Service, North Central Forest Experiment Station
Keywordsrake angle, hard maple, machining defects, chipped grain
- Field identification of birdseye in sugar maple (Acer saccharum Marsh.)
- Variation in Density of Sugar Maple Sapwood and Heartwood
- Defect indicators in sugar maple--a photographic guide.
XML: View XML