Skip to Main Content
Manufacturing interior furniture parts: a new look at an old problemAuthor(s): Edwin L. Lucas; Philip A. Araman
Source: Res. Pap. NE-334. Upper Darby, PA: U.S. Department of Agriculture, Forest Service, Northeastern Forest Experiment Station. 6p.
Publication Series: Research Paper (RP)
Station: Northeastern Research Station
PDF: Download Publication (909.68 KB)
DescriptionThe yields of interior furniture parts from four manufacturing sequences were compared. In three of the sequences, gang-ripping was the first step; in the fourth, the lumber was crosscut first. Though the grade of lumber used affects the percentage yield of parts, the manufacturing sequence used does not - but it will affect the cost per part. The selection of the best method must be based on factors other than parts yield.
- Check the Northern Research Station web site to request a printed copy of this publication.
- Our on-line publications are scanned and captured using Adobe Acrobat.
- During the capture process some typographical errors may occur.
- Please contact Sharon Hobrla, firstname.lastname@example.org if you notice any errors which make this publication unusable.
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationLucas, Edwin L.; Araman, Philip A. 1975. Manufacturing interior furniture parts: a new look at an old problem. Res. Pap. NE-334. Upper Darby, PA: U.S. Department of Agriculture, Forest Service, Northeastern Forest Experiment Station. 6p.
KeywordsLumber yield, furniture manufacture, wood utilization
- An automated rough mill for the production of interior furniture parts
- Improving lumber yield using a dual system
- A Comparison of Four Techniques for Producing High-Grade Furniture Core Material From Low-Grade Yellow-Poplar
XML: View XML