Skip to Main Content
Economic feasibility of manufacturing COM-PLY studs in the SouthAuthor(s): Gerald A. Koenigshof
Source: Res. Pap. SE-197. Asheville, NC: U.S. Department of Agriculture, Forest Service, Southeastern Forest Experiment Station. 26 p.
Publication Series: Research Paper (RP)
Station: Southeastern Forest Experiment Station
PDF: View PDF (2.5 MB)
DescriptionThe investment and production cost required to manufacture COM-PLY studs in the South are presented. It is possible to obtain a 20 percent or greater internal rate of return on an investment in manufacturing COM-PLY.
- You may send email to firstname.lastname@example.org to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationKoenigshof, Gerald A. 1978. Economic feasibility of manufacturing COM-PLY studs in the South. Res. Pap. SE-197. Asheville, NC: U.S. Department of Agriculture, Forest Service, Southeastern Forest Experiment Station. 26 p.
- Economic feasibility of manufacturing COM-PLY floor joists
- Structural Performance of COM-Ply Studs Made with Hardwood Veneers
- Evaluation of veneer yields and grades from yellow-poplar, white oak, and sweetgum from the southeast
XML: View XML