Skip to Main Content
An analysis of the lumber planning process: Part IAuthor(s): Peter Koch
Source: Forst Products Journal, 255-264
Publication Series: Miscellaneous Publication
PDF: View PDF (2.55 MB)
DescriptionReport of study of the peripheral-milling process of planing lumber. Relationships were determined between cutterhead horsepower and various combinations of specimen, cutterhead, and feed factors. Power demand curves are interpreted by comparion with simultaneous one micro-second photos of chips. Secondary consideration is given to quality of surface obtained. The cutterhead variables, feeds, and speeds are in range of theose commonly used in industry.
- You may send email to email@example.com to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationKoch, Peter. 1955. An analysis of the lumber planning process: Part I. Forst Products Journal, 255-264
- An analysis of the lumber planning process: Part II
- Surface quality varies with headrig chipping
- Development of the Shaping-lathe Headrig
XML: View XML