Skip to Main Content
Determining tensile properties of sweetgum veneer flakesAuthor(s): Eddie W. Price
Source: Forest Products Journal, VOl. 26(10: 50-53
Publication Series: Miscellaneous Publication
PDF: View PDF (873 KB)
DescriptionRotary-cut sweetgum veneer flakes measuring 3 inches along the grain, 3/8 inch wide, and 0.015 inch thick, were stressed in tension parallel to the grain at gage lengths from 0.50 to 1.25 inches for unpressed control and at 0.75 inch gage length for flakes pressed in a flakeboard mat. The control fkaes had an average tensile strength of 9,400 psi for the smaller gage length classes, 8,000 psi for the upper range of gage lengths, and moduli averaging from 460,000 psi to 675,000 psi. Platen pressure with heat increased core flake density by 6.3 percent and face flake density by 13.9 percent above that of untreated control flakes. Core flakes, which had an average Mc of 6.3 percent, decreased 6.5 percent and 7.25 percent in tensile strength and modulus, respectively. Face flakes, which had an average MC of 5.5 percent, had 7.6 percent greater tensile strength and 9.8 percent greater modulus than unpressed control. Unpressed control flakes had an average MC of 6.5 percent.
- You may send email to firstname.lastname@example.org to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationPrice, Eddie W. 1976. Determining tensile properties of sweetgum veneer flakes. Forest Products Journal, VOl. 26(10: 50-53
- Determining tensile properties of sweetgum veneer flakes
- Exterior structural composite panels with southern pine veneer faces and cores of southern hardwood flakes
- Slash pine rootwood in flakeboard
XML: View XML