Skip to Main Content
High-frequency and hot-platen curing of medium-density fiberboardsAuthor(s): Robert R. Stevens; George E. Woodson
Source: Forest Products Journal, Vol. 27(1): 46-50
Publication Series: Miscellaneous Publication
PDF: View PDF (1.10 MB)
DescriptionThe effects of two curing methods-high-frequencey heating and hot-platen heating-on the properties of a ureaformaldehyde-bonded medium-density fiberboard prepared with a southern-hardwoods furnish (50% southern read oak, 25% mockernut hickory, and 25% sweetgum) were studied. Boards of three densities-38, 44, and 50 lb./ft3-were cured by the two heating methods. IB strength of the high-frequency-cured boards was greater than that of the hot-platen-cured boards at all density levels. Bending properties of the high-frequency-cured boards exceeded those of the hot-platen-cured boards at the highest density level, only. There were no significant differences attributable to the two curing methods in tension parallel to the surface, linear expansion, and thickness swelling.
- You may send email to email@example.com to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationStevens, Robert R.; Woodson, George E. 1977. High-frequency and hot-platen curing of medium-density fiberboards. Forest Products Journal, Vol. 27(1): 46-50
- High-frequency and hot-platen curing of medium-density fiberboards
- Biomass of Four Hardwoods from Lower Piedmont Pine-Hardwood Stands in Alabama
- Flakeboard properties as affected by flake cutting techniques
XML: View XML