Skip to Main Content
SEM technique for displaying the three-dimensional structure of woodAuthor(s): Charles W. McMillin
Source: Wood Science, Vol.9(4): 201-204
Publication Series: Miscellaneous Publication
PDF: View PDF (397 KB)
DescriptionSamples of green Liriodendron tulipifera L. were bandsawed into 1/4-inch cubes and boiled in water for 1 hour. Smooth intersecting radial, tangential, and transverse surfaces were prepared with a handheld, single-edge razor blade. After drying, the cubes were affixed to stubs so that the intersection point of the three sectioned surfaces was uppermost. specimens were then coated with carbon followed by gold-palladium. A three-sided reflective shield measuring 6.5 cm long by 4 cm deep and 4 cm high was made of thin-gage polished sheet metal and affixed to the goniometric stage in a position opposite the secondary electron detector. Holes in the bottom surface accepted the stubs which could be rotated about their axes. Micrographs illustrate that with the shield in place all three surfaces can be equally highlighted.
- You may send email to firstname.lastname@example.org to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationMcMillin, Charles W. 1977. SEM technique for displaying the three-dimensional structure of wood. Wood Science, Vol.9(4): 201-204
- SEM technique for displaying the three-dimensional structure of wood
- Precipitation measurements on wind-swept slopes
- Long-term response of yellow-poplar to thinning in the southern Appalachian Mountains
XML: View XML