Skip to Main Content
RAMP: a computer system for mapping regional areasAuthor(s): Bradley B. Nickey
Source: Gen. Tech. Rep. PSW-GTR-12. Berkeley, CA: Pacific Southwest Forest and Range Exp. Stn., Forest Service, U.S. Department of Agriculture: 9 p
Publication Series: General Technical Report (GTR)
Station: Pacific Southwest Research Station
PDF: Download Publication (1.7 MB)
DescriptionUntil 1972, the U.S. Forest Service's Individual Fire Reports recorded locations by the section-township-range system..These earlier fire reports, therefore, lacked congruent locations. RAMP (Regional Area Mapping Procedure) was designed to make the reports more useful for quantitative analysis. This computer-based technique converts locations expressed in section-township-range notations into latitude-longitude coordinates. Two subsystems make up RAMP. The technique can be applied to other types of land-management problems.
- You may send email to firstname.lastname@example.org to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationNickey, Bradley B. 1975. RAMP: a computer system for mapping regional areas. Gen. Tech. Rep. PSW-GTR-12. Berkeley, CA: Pacific Southwest Forest and Range Exp. Stn., Forest Service, U.S. Department of Agriculture: 9 p
Keywordsfire case histories, burn pattern, mapping systems, coordinates, locations, computer programs, RAMP, Regional Area Mapping Procedure
- Effect of processing parameters on the synthesis of lignin-based graphene-encapsulated copper nanoparticles
- Non-timber forest products: ramps in the Waynesville, NC watershed
- Customer satisfaction at US Army Corps of Engineers-administered lakes: a compilation of two years of performance data
XML: View XML