Skip to Main Content
An evaluation of underwater epoxies to permanently install temperature sensors in mountain streamsAuthor(s): Daniel J. Isaak; Dona L. Horan
Source: North American Journal of Fisheries Management. 31:134-137.
Publication Series: Scientific Journal (JRNL)
Station: Rocky Mountain Research Station
PDF: Download Publication (104.6 KB)
DescriptionStream temperature regimes are of fundamental importance in understanding the patterns and processes in aquatic ecosystems, and inexpensive digital sensors provide accurate and repeated measurements of temperature. Most temperature measurements in mountain streams are made only during summer months because of logistical constraints associated with stream access and concerns that large annual floods will destroy sensor installations. We assessed six underwater epoxies to determine whether sensors could be attached to large rocks already in streams to provide durable installations and whether temperature measurements would be biased by heat conduction through the rocks. Only one of the six test epoxies bonded the sensors firmly to rock surfaces in laboratory trials. In subsequent field trials, 9 of 11 sensors attached to rocks with this epoxy successfully weathered above-average floods in four Idaho and Nevada streams in 2010. Comparisons of daily maximum, minimum, and mean temperatures between rock-mounted sensors and control sensors at 10 rocks suggested temperature measurements were not biased by attachment to rocks. We also assessed the effect of direct sunlight on sensors by removing solar shields from some sensors and noted rapid and statistically significant increases in daily means (+0.21 °C) and maxima (+0.54 °C), but not minima (−0.01 °C). Use of underwater epoxy for permanent installation of temperature sensors in mountain streams is a viable technique if an appropriate epoxy is chosen, sensors are shielded from direct sunlight, and rocks large enough to withstand floods are used. Moreover, installations using epoxy are rapid (approximately 20 min), and firm attachments to rock surfaces over a range of stream temperatures (5–20 °C) are possible.
Related web site: Stream Temperature Modeling and Monitoring
- You may send email to firstname.lastname@example.org to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationIsaak, Daniel J.; Horan, Dona L. 2011. An evaluation of underwater epoxies to permanently install temperature sensors in mountain streams. North American Journal of Fisheries Management. 31:134-137.
Keywordsepoxies, stream temperature
- A simple protocol using underwater epoxy to install annual temperature monitoring sites in rivers and streams
- Design and evaluation of an inexpensive radiation shield for monitoring surface air temperatures
- Influence of maximum water temperature on occurrence of Lahontan cutthroat trout within streams
XML: View XML