Skip to Main Content
Post-fire mulching for runoff and erosion mitigation; Part I: Effectiveness at reducing hillslope erosion ratesAuthor(s): Peter R. Robichaud; Sarah A. Lewis; Joseph W. Wagenbrenner; Louise E. Ashmun; Robert E. Brown
Source: Catena. 105: 75-92.
Publication Series: Scientific Journal (JRNL)
Station: Rocky Mountain Research Station
Download Publication (1.88 MB)
DescriptionMulch treatments often are used to mitigate post-fire increases in runoff and erosion rates but the comparative effectiveness of various mulches is not well established. The ability of mulch treatments to reduce sediment yields from natural rainfall and resulting overland flow was measured using hillslope plots on areas burned at high severity following four wildfires in the western United States. Wheat straw mulch, wood strand mulch, and hydromulch were evaluated along with untreated control plots on multiple fires for 4 to 7 years after burning. Needle cast from fire-killed conifer trees was evaluated in an area of moderate burn severity at one fire, and seeding with genetically native seed was tested, with and without hydromulch, at another fire. Rainfall, ground cover, and soil water repellency were measured in each treatment site at all 4 fires.Mean sediment yields on the control plots ranged from 0.3 to 7.5 Mg ha-1 in the first post-fire year, from0.03 to 0.6 Mg ha-1 in the second, and from 0 to 0.4 Mg ha-1 in the third and fourth post-fire years. Assuming a linear fit between sediment yield and rainfall intensity, stormswith equivalent rainfall intensities produced nearly an order ofmagnitude less sediment on the control plots in the second post-fire year as compared to the first post-fire year. Large storms (at least a 2-year return period, 10-min maximum rainfall intensity) produced sediment on all fires in all years where they occurred; however, sediment yields produced by large storms that occurred in the first post-fire year were larger than the sediment yields from equivalent storms that occurred in later years at the same fire. Sediment yields decreased as ground cover increased and all the mulch treatments increased total ground cover to more than 60% immediately after application. However, the longevity of the mulches varied, so that the contribution of the treatment mulch to total ground cover varied by mulch type over time. The wood strand mulch was the most long-lived of the mulch treatments and was observed in ground cover assessments throughout the study period (4 and 7 years) at two fires. The wheat straw mulch decreased nearly twice as fast as the wood strand mulch, and no hydromulch was detected after the first post-fire year on either fire where it was tested.
- You may send email to email@example.com to request a hard copy of this publication.
- (Please specify exactly which publication you are requesting and your mailing address.)
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationRobichaud, Peter R.; Lewis, Sarah A.; Wagenbrenner, Joseph W.; Ashmun, Louise E.; Brown, Robert E. 2013. Post-fire mulching for runoff and erosion mitigation; Part I: Effectiveness at reducing hillslope erosion rates. Catena. 105: 75-92.
Keywordspost-fire rehabilitation, wheat straw mulch, wood strand mulch, hydromulch, seeding, needle cast
- Vegetation response after post-fire mulching and native grass seeding
- Post-fire mulching for runoff and erosion mitigation; Part II: Effectiveness in reducing runoff and sediment yields from small catchments
- Effects of fire severity and pre-fire stand treatment on plant community recovery after a large wildfire
XML: View XML