Skip to Main Content
U.S. Forest Service
Caring for the land and serving people

United States Department of Agriculture

Home > Search > Publication Information

  1. Share via EmailShare on FacebookShare on LinkedInShare on Twitter
    Dislike this pubLike this pub
    Author(s): Carmen Regalado; D. Earl Kline; Philip A. Araman
    Date: 1992
    Source: Forest Products Journal. 42(3): 29-34.
    Publication Series: Miscellaneous Publication
    PDF: View PDF  (66 KB)

    Description

    Due to the limited capability of board defect scanners, not all defect information required to make the best edging and trimming decision can be scanned for use in an automated system. The objective of the study presented in this paper was to evaluate the lumber value obtainable from edging and trimming optimization using varying levels of defect information as input. In an earlier study, a computer-based procedure for estimating optimum edging and trimming solutions was developed. The same procedure was used in the optimization experiments in this study. Instead of complete defect data that the procedure ideally requires, a combination of selected defect types was used for each optimization experiment. The sample for the study consisted of 120 unedged/untrimmed red oak boards collected from three hardwood mills. The value recovery calculated from the different defect information categories is presented and compared to the lumber values calculated from complete board defect data, as well as to the lumber values actually obtained in the sawmill from the same boards. The results showed that it is possible to obtain lumber values higher than actual sawmill output from a computer-based edging and trimming optimization procedure even if not all board defects are considered.

    Publication Notes

    • You may send email to pubrequest@fs.fed.us to request a hard copy of this publication.
    • (Please specify exactly which publication you are requesting and your mailing address.)
    • We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
    • This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.

    Citation

    Regalado, Carmen; Kline, D. Earl; Araman, Philip A. 1992. Value of Defect Information in Automated Hardwood Edger and Trimmer Systems. Forest Products Journal. 42(3): 29-34.

    Related Search


    XML: View XML
Show More
Show Fewer
Jump to Top of Page
https://www.fs.usda.gov/treesearch/pubs/47