Skip to Main Content
Data for prediction of mechanical properties of aspen flakeboardsAuthor(s): C. G. Carll; P. Wang
Source: (Research note FPL ; 0246):8 p. : ill. ; 28 cm.
Publication Series: Research Note (RN)
Station: Forest Products Laboratory
Download Publication (68 KB)
DescriptionThis research compared two methods of producing flakeboards with uniform density distribution (which could then be used to predict bending properties of flakeboards with density gradients). One of the methods was suspected of producing weak boards because it involved exertion of high pressures on cold mats. Although differences were found in mechanical properties of boards produced by the two methods the differences were not great. This suggests that exertion of high pressures on cold mats does not cause great reduction in board properties. Unfortunately, the equipment used to produce boards resulted in inclusion of an extraneous variable. Hence the study data cannot prove that exertion of high pressure is inconsequential.
- We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
- This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.
CitationCarll, C. G.; Wang, P. 1983. Data for prediction of mechanical properties of aspen flakeboards. (Research note FPL ; 0246):8 p. : ill. ; 28 cm.
KeywordsMechanical properties, Pressure, Flakeboards, Bending strength, Stiffness, Cold pressing, Steam injection, Cold mats, Uniform density, Distribution
- Influence of board density, mat construction, and chip type on performance of particleboard made from eastern redcedar
- Construction variables considered in fabrication of a structural flakeboard
- Effects of A New Caul System on Strength and Stability of Structural Flakeboard
XML: View XML