Skip to Main Content
U.S. Forest Service
Caring for the land and serving people

United States Department of Agriculture

Home > Search > Publication Information

  1. Share via EmailShare on FacebookShare on LinkedInShare on Twitter
    Dislike this pubLike this pub
    Author(s): Chung-Yun Hse; Robert L. Geimer; W. Earnest Hsu; R.C. Tang
    Date: 1995
    Source: Forest Products Journal 45(1):57-62
    Publication Series: Miscellaneous Publication
    PDF: View PDF  (1.4 MB)

    Description

    Six potentially important wood adhesives for gluing southern pine and white oak flakeboards were evaluated for their performances in steam-injection pressing and conventional platen pressing. Of the six resins tested, polyisocyanate resin performed well in both steam injection and conventional platen pressings. Phenol-formaldehyde (PF) and melamine urea-formaldehyde (MUF) resins performed poorly in steam-injection pressing. However, adding a small amount of polyisocyanate improved performance considerably. Bending strengths were consistently higher with conventional platen pressing than with steam-injection pressing. The lower density face in steam-injection pressing would result in lower bending properties. In PF and MUF resin systems, steam-injection pressing resulted in low bond strength and high dimensional stability, whereas conventional platen pressing resulted in high bond strength and low dimensional stability. The pairing of low strength with high stability suggested that bonding strength could not be the cause of improvement in dimensional stability. Most probably, steam pressing reduced internal stresses and stabilized the flakes, which in turn resulted in an improvement in dimensional stability. The improvement in dimensional stability may also be related to less strength loss of the board in steam-injection pressing when exposed to high relative humidity treatment.

    Publication Notes

    • You may send email to pubrequest@fs.fed.us to request a hard copy of this publication.
    • (Please specify exactly which publication you are requesting and your mailing address.)
    • We recommend that you also print this page and attach it to the printout of the article, to retain the full citation information.
    • This article was written and prepared by U.S. Government employees on official time, and is therefore in the public domain.

    Citation

    Hse, Chung-Yun; Geimer, Robert L.; Hsu, W. Earnest; Tang, R.C. 1995. Effect of resin type on properties of steam-press-cured flakeboards. Forest Products Journal 45(1):57-62

    Related Search


    XML: View XML
Show More
Show Fewer
Jump to Top of Page
https://www.fs.usda.gov/treesearch/pubs/8066